Aiphone Intercom System A User Manual

Vandal and Weather Resistant Sub Stations  
- INSTRUCTIONS -  
The NE-SS/A and NE-SSR are 2-gang vandal proof and weather resistant sub stations designed for use with the NEM,  
NDR and NDRM systems. They are constructed of 12 gauge stainless steel and are equipped with an option for an  
external output contact closure when the sub station places a call (relay required). The units either flush mount into a 2-  
gang box, or surface mount with the SBX-2G. Each unit includes tamper proof screws and a tool for installation. The  
NE-SSR features a red mushroom call button.  
INSTALLATION:  
1. For flush mounting, install sub station in standard 2-gang electrical box with min. 2-1/2" depth.  
2. For surface mounting, install sub station in the SBX-2G surface mount enclosure.  
3. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and  
evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the  
unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If  
sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from  
dissipating from inside the unit, which may cause corrosion or deterioration to the internal components over time.  
MOUNTING:  
2-GANG BOX  
NE-SS/A  
NE-SSR  
TORX  
screws  
Do not apply sealant  
between unit and box.  
WIRING DIAGRAM:  
NOTES:  
NE-SSA/-SSR  
NEM Master  
NE-SSA/-SSR  
1. The units flush mount into a 2-gang box.  
2. To surface mount the NE-SS/A or NE-SSR, order  
the SBX-2G surface mount box separately.  
(w/dry closure output)  
Red  
1
2
Red  
3
NE-SSA/-SSR  
(w/corridor lamp)  
~
20  
Red  
PS-2420UL  
Blk  
Blu  
Blk  
Blu  
E
+
-
+
-
Wht  
Blk  
Blk  
Blk  
Blu  
H
Blu  
Blu  
RY-PA  
Dry closure  
output for  
duration of call-in  
Yel  
NBY-4A  
WIRE DESIGNATIONS:  
Red: + side of speaker. Connect to station number on master station.  
Blue: Trigger for corridor lamp. 7V DC when call-in signal is activated.  
Black: - side of speaker, Common. Connect to E on master station.  
White: Negative trigger wire for extra relay contact closure at sub during call.  
Small wht & blk: Speaker connection to PCB  
Small brn (x2): Call button connection to PCB  
Page 1  
 

Acclaim Lighting Camera Accessories ACCLAIM USB ONLY INTRAORAL DIGITAL VIDEO CAMERA SYSTEM User Manual
Accusplit Fitness Electronics 1520M2 User Manual
Alliance Laundry Systems Washer B Series User Manual
Alpine Fish Finder SWR M100 User Manual
Amana Clothes Dryer NGD4500V User Manual
AMX Stereo System DAS T0804 SIG User Manual
Atlona Car Amplifier AT SAV14 User Manual
Axis Communications Home Security System 2130 PTZ User Manual
Barco Network Router DVI 16X16 User Manual
Behringer Stereo Amplifier AC108 User Manual