Audiovox CDC FDR User Manual

INSTALLATION GUIDE FOR:  
CD CHANGER  
INTERFACE CABLE  
for FORD VEHICLES  
Models CDC-FDF & CDC-FDR  
Form No. 128-5315  
CAUTION: FOLLOW THE CONNECTION SEQUENCE DESCRIBED BELOW TO ENSURE PROPER  
RECOGNITION OF THE CD CHANGER BY THE FACTORY RADIO.  
DO NOT FORCE CONNECTORS TOGETHER. LINE UP LOCATING TABS AND CAREFULLY  
MATE CONNECTORS.  
INSTALLATION INSTRUCTIONS FOR THE CDC-FDR: (Fig. 1)  
IMPORTANT : Vehicles with electronic heating/AC controls may experience intermittent operation of these controls  
when the CD Changer is disconnected.  
1. Mount the CD changer at the desired location in the trunk following the installation instructions supplied  
with the CD changer.  
2. Carefully connect the 8-pin circular DIN connector from the CDC-FDR to the mating socket on the CD  
Changer.  
3. Route the CDC-FDR cable toward the factory tuner/amplifier pack located in the rear left wheel well.  
4. With the vehicle off, unplug the power/speaker connector from the tuner/amplifier pack.  
5. Carefully connect the data cable from the CDC-FDR to the mating socket on the tuner/amplifier pack.  
6. Carefully connect the vehicle side power/speaker cable to the mating connector on the CDC-FDR.  
7. Carefully connect the power/speaker connector from the CDC-FDR to the mating socket on the tuner/  
amplifier pack.  
INSTALLATION INSTRUCTIONS FOR THE CDC-FDF: (Fig. 2)  
IMPORTANT : When mounting the CD Changer in the rear of the vehicle, it may be necessary to purchase  
separately the AK-98-CDA, data cable adaptor. The AK-98-CDA allows the 20-foot data cable  
supplied with the CD Changer to connect to the CDC-FDF.  
1. Mount the CD Changer at the desired location either in the center console (CDC-620 only) or in the rear of  
the vehicle. Refer to the installation instructions supplied with the CD Changer.  
2. Carefully connect the 8-pin circular DIN connector from the CDC-FDF to the mating socket on the CD  
Changer. The AK-98-CDA may be required when rear mounting the CD Changer.  
3. Route the CDC-FDF cable toward the factory radio.  
4. Remove the factory radio from the dash panel using the factory removal tools.  
5. Unplug both the power/speaker and CD Changer connectors from the rear of the radio.  
6. Carefully connect the vehicle power/speaker and CD Changer connectors to the respective mating con-  
nectors on the CDC-FDF.  
7. Carefully connect the power/speaker and CD Changer connectors of the CDC-FDF to the respective  
mating connectors at the rear of the radio.  
OPERATION CHECK:  
1. Load CD's into the CD Changer cartridge and insert the cartridge into the changer.  
2. Start vehicle and allow CD Changer to cycle.  
Perform a brief functional test to verify proper operation according to the owner's manual.  
Audiovox Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788  
Printed in China  

Adaptive Sound Technologies Car Speaker 9000 User Manual
Aiphone LAF 40CA User Manual
Atlantis Land A03 S801 User Manual
Canon XF200 9593B002 User Manual
FujiFilm FinePix S4500 User Manual
Gefen GEF HDMI1 3 2 3GSDI User Manual
Hamilton Beach 840095300 User Manual
Hasselblad Lenses 0 5 User Manual
HP (Hewlett Packard) Hewlett Packard Car Video System 82913A User Manual
Jensen MP6211 User Manual